The famous MHR intake kit for MINARELLI am6 engines and derbi 50cc euro 1, 2, 3 engine ... This pack consists of very large parts, the pipe is certainly the best existing model for these engines! At the same time as being fully orientable, flexible, special absorption of harmful vibrations on the carburation level, the pipe is specially designed to diffuse the gas mixture without any loss !! This pipe coupled with the superb diffuser of the VL6 by MALOSSI valves will bring you a perfectly aligned intake! The vl6 valves are racing valves with a studied base, equipped with drilled slat stops, very high quality 0.30mm carbon slats! This pack is already a must and is used for the cup gp 80 (20cv and more), for the mhr team carburetion packs Ø 21, 28 and 26mm. We greatly appreciated the easily adjustable pipe (up, down, left, right ...), the high quality rubber, the cast / machined aluminum pipe flange mhr ... In addition, this pack is very complete! This model has a Viton sleeve, Viton is used for pipe racing, it is more efficient for the scrubbing of vibrations, throttle rebounds… And is much more solid than rubber.
We recommend this pack on DELLORTO or other carburettors from Ø19mm to Ø22mm. In male fixing diameter from 24 to 26mm.
(* this pack also exists in rubber version)
The mhr viton Ø 21 admission pack contains :
Super reinforced screws (4 washers + 4 screws)
21mm Viton intake tube
Valves vl6 complete with diffuser
Intake gasket
Carburetor clamp
Notice
Sticker
Spare parts :
Valve seal
21mm Viton sleeve
Carburizing flange
Diffuser for dampers
Hose clamp
Complete vl6 valves
.png)
