Reference: 2707
only idle screw for carburettor DELLORTO PHBG
The idle screw without its spring for your PHBG!
Banner
For your Dellorto PHBG carburettor since 2020 with screw-on cover, we now offer you the extra thin and extra flat screw-on valve cover!
Delivered as presented, without lid seal. Takes up less space with a vertical draw, be careful, does not fit on old PHBGs with a two-screw valve cover!
For all Dellorto PHBG carburetors from 2020 with screw-on cover
*Also mounts on BLACK EDITION and RED EDITION before 2020
Reference: 2707
The idle screw without its spring for your PHBG!
Reference: 10431
The bowl bottom also called anti-emulsion washer ... Indispensable for the proper functioning of your carburetor and oil / gasoline mixing!
Reference: 05 3733B
Ideal to increase the venturi effect so your performance.
Reference: 09450
The replacement float for your carbs, ideal in the event of a fuel leak!
Reference: 01476_00
The original cap of all DELLORTO carburetor. Perfect for any loss or breakage of your old cap.
Reference: 53002_00
A pack to switch your PHBG carburettors choke lever to cable choke!
Reference: 53027_00
The idle screw with its spring for your PHBG carburettors!
Reference: 53129_00
Ideal in case of loss or to pass your cable as desired.
Reference: 53036_00
Ideal in case of loss or change the passage of your cable.
Reference: 09597_00
The valve spring for your carbs, ideal when the handle returns badly or in the event of loss, wear, breakage...
Reference: 18951-53
The replacement cover for your DELLORTO PHBG carburettors, to screw.
Reference: 09814_00
A tulip which increases the venturi effect and therefore the efficiency of your engine. In addition to this, you need to know more about it.
Reference: 263991
A complete kit that will allow you to pass your cables as you wish.
Reference: 09811_00
The aluminum racing tank, mounts on all PHBG carburettors, to remove your jets faster, drain faster and get more strength!
Reference: 1298
The little room in which hangs the starter cable.
Reference: 09812
A mass-machined brass cap for your carburetors with aluminum tank or racing black edition!