
Reference: 01476_00
sheath cap only universal DELLORTO
The original cap of all DELLORTO carburetor. Perfect for any loss or breakage of your old cap.
Banner
Adjusting screw and setting accelerator cable without additional trimmer, thread size 19,70mm end Ø6mm surroundings. Thread length 12mm single, true DELLORTO. Ø 6,90mm for the sheath, internal diameter 3.5mm cable crossing. For carburettors DELLORTO. Also available with additional angled adjuster.
Reference: 01476_00
The original cap of all DELLORTO carburetor. Perfect for any loss or breakage of your old cap.
Reference: 1298
The little room in which hangs the starter cable.
Reference: 506367
The counter nut that locks your cable tension adjuster on DELLORTO carburettor.
Reference: 1282
Ideal for lost or just for a refurbishment without spending too much.
Reference: 53016_00 / B53016B
Kit of complete collar for rigid carburettor PHBG and SHBC!
Reference: 493928
A very aesthetic tank delivered with its seal and screws for a very good price!
Reference: 09811_00
The aluminum racing tank, mounts on all PHBG carburettors, to remove your jets faster, drain faster and get more strength!
Reference: 01104_00
Arises directly in the plug cover, also available in angled with adjuster.
Reference: 53002_00
A pack to switch your PHBG carburettors choke lever to cable choke!
Reference: 53036_00
Ideal in case of loss or change the passage of your cable.
Reference: 09779_00
Essential part of your carburettor PHBG for better mixing oil / petrol! Not deep model for jet small step 5mm.
Reference: 4477.62
The ring which seals and tightens your intake pipes with your RIGID PHBG!
Reference: 129514
For a refurbishment at a lower cost for a perfect seal.
Reference: 09596_00
Ideal in case of loss or breakage.
Reference: 343.0021
Ideal in case of loss or to pass your cable as desired.
Reference: AP8106790
A tulip that increases the venturi effect therefore the performance of your engine.