Malossi S.p.A. is pleased to make available to its customers a new series of primary transmission gears for 50cc scooters.
These new gears are the result of the 20 years of Malossi experience in the study and realization of gears for competition and road scooters.
The new H. t. Q. gears were studied and made with straight teeth to minimize friction losses and loads on the supports. In addition, our gears lightly lengthen the gears, allowing you to exploit all the power of your scooter and guarantee a considerable sprint compared to your original scooter.
The transmission is extremely important in a good preparation, if your torque variator and corrector are at their maximum, that your speed speed speed minute also and that the peak speed is not enough for you! Just change your transmission in order to exploit your peak speed at the bottom by losing quite obviously some can of acceleration, it will also allow settings, a different torque, it will have to be accompanied by new variator/ thrust range settings. We recommend it with a racing cardr mounted on bearings and a good transmission oil. The primary transmission is that on which the clutch bell is fixed, there are also secondary transmissions. Transmission MALOSSI MHR is a real racing piece, they are known to be indestructible! Enjoy it. Before buying, we advise you to observe your primary and secondary transmission in order to know its tooth and thus judge which to take. We preconceive a rodage of about 100km and an oil drain after 1000/1300 km.
Attention, on this transmission the teeth are bigger than the origin so the report is completely modified despite the counting of the teeth!
In addition, this transmission is in straight toothing instead of being like the origins or top performance(TPR) in leaned tooth. The right tooth allows extra power, much less forcing level transmission, less noise...Nous advise in any way a rolling transmission cardr that will pose less trouble and more performance.
There are 2 primary transmissions MALOSSI MHR for motor minarelli scooter
Z(denture)= 16/40 Long report (longer than POLINI again)
Z(denture)= 13/44 Semi-long ratio (identical to semi-growing POLINI)
Select the desired tooth before purchase.
No more than in 16/40
.jpg)
