C. BOUCHET intake pipe for carburetor from 19 to 21mm PHBG or CP on Peugeot Fox

Attention it is delivered without seal, to pose with paste ATHENA ATHESIL! Hey! Couple lock with a dynamometer tool mandatory (about 4.5nm recommended)!

Competition intake pipe C. BOUCHET printed in 3D in a specific material resistant very well to heat! This pipe allows the installation of carburetors POLINI CP 15 to 21mm or DELLORTO PHBG 15 to 21mm. The pipe, designed by a motorist, is obviously designed for maximum performance. It comes with a flexible oil resistant anti-vibration sleeve, its two collars and its screws! A very beautiful piece, indispensable for large engine configurations PEUGEOT FOX! An advantage of flexible mounting and 3D printing is the thermal cut-off between the carburettor and the engine to heat the gas mixture in the carburettor.

This is the direct competitor of the pipe MALOSSI, the MALOSSI is more solid and robust in time, aluminum, it is not subject to deformation, however, it is more expensive and in mounting RIGIDE!

*The installation of carburettors from 15 to 17.5mm although possible, is not recommended, the pipe is designed to lay from 19 to 21mm!