Reference: 146909
Needle sleeve 12X16X10mm P2R in reinforced insert, for minarelli am6 engine gearbox
Ideal for refurbishing your minarelli am6 gearbox.
Banner
Pinion gearbox input shaft on, original type reinforced TOP PERFORMANCES. This gear is the fifth report, it will serve you in case of 5th gear breakage, always remember to check all gearing during a break in order to buy the right gears. This gear has 24 teeth.
Reference: 146909
Ideal for refurbishing your minarelli am6 gearbox.
Reference: 148604
Quality piece, ideal in case of breakage or wear of your old original cap on AM6 engine.
Reference: 146909
Ideal for the refurbishment of your minarelli am6 gearbox. Allows the axle to be mounted on a bearing!
Reference: AM00017
Original element for minarelli am6 engine.
Reference: AM00007
A special gear of high quality, ideal for changing your 3rd & 4th gear on the input shaft.
Reference: 32171
A high quality gear, ideal for start fresh on your engine.
Reference: 32186
A pinion original type of kick axis and cheaper than in concession. Ideal for refurbishment of your engine down!
Reference: AM00030
Ideal for refurbishing or adapting a kick system!
Reference: AP8206245
Spare parts essential for the passage of an intake kit with large carburettor DERBI.
Reference: 9931910
Ideal for gaining top speed on your 50cc motorcycle with Minarelli am6 engine, without losing acceleration!
Reference: 32185
Here is the original type full kick axle from P2R. Indispensable element, ideal in case of breakage or wear of your old part. Very good quality at an attractive price, mounts on mécaboite minarelli am6.
Reference: 504841
A box of complete circlips that will allow you to make all your repairs, changes.
Reference: 511495
Reinforced element for clutch support, allows a better maintenance of the cable!
Reference: 504841...8
Clips that will allow you to do all your repairs, changes.
Reference: 32184
An element of very good quality, ideal for the refurbishment of your oil pump system.
Reference: 9935100
A high quality gear, ideal to change your first report on the output shaft.