Attention parts only reserved for the competition, prohibited on road!
Here is the 70cc cast in BARIKT in 70cc Ø47mm. This affordable cylinder does not neglect the quality or performance, this 47mm diameter cast iron. It has 5 admission and transfers normal exhaust (oval).
Charts are pretty high at admission and low enough to escape making the torquey and not difficult to follow or set. The piston is a two-segment model! Clearly this kit has a very good ratio torque / power, it offers plenty of performance while preserving a great strength!
The piston is therefore bi-model segments with segments purposes, chrome, hard, bulging. It has a light preparation on the rear apron to improve scanning and filling of admission. The finish is very good quality.
The cylinder head high compression polished hemispheric model. This kit will certainly be less effective than MALOSSI MHR, BIDALOT or Polini ... But there will already very good.
We recommend to accompany this kit with: carburation 19mm (carbon flaps slats 0.30mm), crankshaft and reinforced bearings, exhaust racing, candle racing ...
The pack contains:
X1 cylinder cast iron 5 transfers
X1 hemispherical aluminum cylinder head chamber
X1 Piston dual segments with preparation rear skirt
X2 Segments, purposes, chrome, hard, bulging 1mm thick
X1 Piston pin Ø12mm X 38mm
X2 piston Clips G
Pack X1 engine top seal
Optional we offer a preparation course 1, this preparation is a modification of the exhaust port by increasing the charts and improvement of the duct, it increases the cylinder performance. Improved bottom skirt is also included in the amendment. Allow a little extra time for this preparation!
Itself on:
-Honda BALI 50 2T
-Honda SH 50 2T 1996->
-Honda SFX 50 2T
-Honda SGX SKY 50 2T
-Honda SXR 50 2T
-Honda X8R 50 2t
-Honda X8R S 50 2T
And other models ...
