Room not approved on road, only reserved with the competition.
This kit MALOSSI is a model without cylinder head, it is intended to be mounted with original cylinder head on KEEWAY, CPI ... making it the cheapest but good enough. The cylinder is a cast iron model Ø47mm reamed in order to increase the cylinder, the piston is a two segment to slow the race, privilege the couple and solidity. It is an axis of 12mm model and it will be supported by your original crankshaft without problems. The cylinder head gasket is a model unlike aluminum complete kit with cylinder head that is cylinder head O-ring. This little kit can really expensive and will bring you the proper torque performance and top speed without requiring a large equipment behind a single exhaust, carburetor settings with index candle 9 (B9ES) will be sufficient to properly operate this little kit.
MALOSSI book with slats KARBONIT valves in order to exploit the good diets and carburetion follow without problems. We suggest this room to those who are home in a country where the law permits to ride every day on road 70cc kit, in case of tightening, this kit you permanent repair and frank increased performance at a lower cost!
We advise to accompany this kit with: carburetors settings B9HS candle racing exhaust pot.
The pack contains:
Piston
segments
Axis 12mm
Pack complete joint
Piston Clips C
cast iron cylinder
Lamella valves
notice
stickers
Optional we offer a preparation course 1, this preparation is a modification of the channels and the exhaust port by increasing the charts and improvement of the duct, it increases the cylinder performance. Improved piston and bottom skirt is also included in the amendment. Allow a little extra time for this preparation!
Itself on:
BENELLI Pepe
BENELLI Quattronovex
CPI Aragon
CPI Hussar
CPI Oliver
CPI Popcorn
EXPLORER Cracker
GARELLI Tiesse
Hüpper Montecarlo
KEEWAY F-act
KEEWAY Matrix
KEEWAY Goccia
KEEWAY Hurricane
KEEWAY Pixel
KEEWAY RY8
And many other models ...
