Reference: 85306.00
Cylinder - Cylinder without piston 70cc Ø45mm PARMAKIT for ZUNDAPP Miniterm CS50, KS50 ...
The piston-cylinder without cylinder head 70cc for ZUNDAPP air cooling for miniterm engines.
Banner
Part become very rare, here is a kit for engines of GUZZI DINGO SPORT 50 2T. This high performance kit from PARMAKIT is very robust, powerful and torquey! It consists of a nicasil treated aluminum cylinder, a single-segment vertex piston! The diagrams, the compression ratio, the ducts ... Everything is studied to obtain an excellent engine performance. It mounts in combination with the original breech! We recommend a 17.5 to 21mm carburetor and a sport exhaust! Piston pin diameter 13mm. Admission below flange 2 screws. Attention, do not mount on GUZZI DINGO standard, for the latter, another kit exists with an intake inlet at the rear of the cylinder!
Optionally we offer a stage 1 preparation, this preparation is a modification of the channels and exhaust light by increasing the diagrams and improving the pipe, it increases the performance of the cylinder. An improvement of the piston and skirt stocking is also included in this modification. Allow a little extra time for this preparation!
Reference: 85306.00
The piston-cylinder without cylinder head 70cc for ZUNDAPP air cooling for miniterm engines.
Reference: 25104.00
PARMAKIT 80cc special kit for old FANTIC CABALLERO. 48X48mm studs.
Reference: 42105.00
Kit very torquey, robust and powerful for KREIDLER FLORET HP 5.2.
Reference: 42307.00
A high-performance and full high special range for motor KREIDLER RS 50 SUPER.
Reference: 168.6006
The POLINI SERIE 6000 kit reproduced for enthusiasts! For 41.6mm stroke.
Reference: 64168.00
A high-performance and full high special range for motor SACHS 503 and 504 in axis of 14mm with 4 transfers with a long-stroke crankshaft.
Reference: 133.6005
The kit POLINI SERIE 6000 reproduced for the passionate ones! For 42mm stroke.
Reference: 85465.00
kit Ø45mm 70cc for ZUNDAP 50 air cooling, admission without valves on cylinder.
Reference: 003800/1
Very high quality 80cc kit, complete with valves and pipe for period MORINI engines!
Reference: 64262.00
A high-performance high-end special engine for SACHS 503 and 504 in axis of 14mm with 4 transfers crankshaft long race.
Reference: 007100
ZUNDAPP is very robust and powerful!
Reference: 074000/1
Very good 70cc kit for SACHS integrated cylinder head! Available with or without intake pipe.
Reference: 073600
80cc kit with inclined admission, more practical for certain carburetion assemblies!
Reference: 53498.00
The very last parmakit for 42mm stroke on MINARELLI P6 engine.
Reference: 85438.00
A 70cc kit for ZUNDAPP air cooling for miniterm engines.
Reference: 64432.00
A complete high-performance high-end engine special for SACHS 503 and 504 with a 14mm axle with 2 transfers with a long stroke crankshaft.