Reference: 009512
ATHENA Racing competition valves minarelli am6
High quality competition valves, bonded aluminum base!
Banner
High quality 80cc ATHENA kit. Ø 48mm big bore, it consists of a high-end nicasil treated aluminum cylinder from EUROCILINDRO.
From an ASSO piston with high silicon content, flat cap with single L-segment.
This excellent set is given with a valve box adhered to the viton with two double slats joined in karbonit fiber, you can mount them with or without slat stops.
Intake plates, muffler ball joint ...
This complete high performance set is obviously very torquey and robust, ideal for refurbishing your old MORINI 2T 50.
As an option we offer you a stage 1 preparation, this preparation is a modification of the channels and the exhaust port by increasing the diagrams and improving the duct, it increases the performance of the cylinder. An improvement to the piston and the bottom of the skirt is also included in this modification. Allow a little extra time for this preparation!
Mounts on old MORINI engines :
Franco Morini 2T G30 - Motorcycles-mopeds
MORINI S5 / GS
KTM SX 50
Malaguti FIFTY FULL CX 50 - 1991/1991 - Motorcycles-mopeds
Moto Gac WINNER 50 - Motorcycles-mopeds
LEM 50
Reference: 009512
High quality competition valves, bonded aluminum base!
Reference: S410000304002
The ATHENA clips of good quality for 12mm axles with 1mm diameter piston groove!
Reference: 001716/R
High-end segment to refurbish and increase your engine compression.
Reference: 021725
The flange has 2 screws for fixing the muffler in Ø29mm ATHENA for P4, P6 ...
Reference: 003803
Pack of complete seal for kit 80cc ATHENA air on MORINI T4, GS, TUNTURI, ZENELLA, PERIPOLI ...