Here is the latest PARMAKIT high performance kit for MINARELLI P6 with long stroke crankshaft 44mm . A set of rare and high-performance parts for old MINARELLI P6 motor bikes RADIAL SISTEM type air cooling, therefore exhaust with 3-screw fixing. With PARMAKIT everything is possible, the proof in pictures!
This high-performance kit has an aluminum cylinder with the new PARMAKIT architecture for more performance (4 intake transfers, bar exhaust). This high quality aluminum cylinder comes straight from the Made in Italy molds! It has 4 large intake transfers with an internal lubrication system in the cylinder and in accordance with its piston. The architecture and finish are of course excellent and upscale.
The Ø48mm piston is obviously a real VERTEX mono-segment with L-shaped segment. The piston pin is Ø12mm. The diagrams are very pronounced for maximum power! A huge bar exhaust and high diagrams make this engine group a powerful asset for your 2 wheels! The piston which accompanies this cylinder is a mono-segment L-shaped model from VERTEX therefore of high quality with preparation on the upper rear part of the piston to improve lubrication and sweeping in the cylinder and low engine.
The large hedgehog breech has a high hemospherical compression chamber. The cooling is excellent! With its L-shaped segment it will offer you the highest revs optimizing the top speed and the climb in the towers! The other particularity of this cylinder is the possibility of placing it for a 44mm stroke with the aluminum wedge of 3mm supplied thus increasing the displacement. Clearly, an excellent quality / price / performance ratio to radically increase the power on your Minarelli P6 motor bike!
The whole is delivered with a block of base for the crankshafts race / long rod.
To accompany with : carburetion in 24mm minimum, crankshaft stroke 44mm, sports exhaust ...
-Ø of the fitting of the skirts, Ø54mm. (53.5mm at the top and 53mm at the bottom exactly)
-Between cylinder studs / cylinder head 48 X 48mm
-Between axis 50mm intake studs
-Between axis 45mm exhaust studs
Some of these kits arrive with a graphite piston
Optionally we offer you a stage 1 preparation, this preparation is a modification of the channels and the exhaust light by increasing the diagrams and improving the duct, it increases the performance of the cylinder. An improvement in the piston and bottom of the skirt is also included in this modification. Allow a little extra time for this preparation!
