Reference: 5926
LOCTITE 5926 blue silicone sealant 100ml
A high-end sealant for maximum resistance and sealing from -60° to + 250°.
Banner
Thank you to refer you to the photo by enlarging it before purchase!
Here is the complete package and very high quality seal in VERTEX marketed by ITALKIT to reformat all your old and rare engines MINARELLI RV3, RV4, RV5, RV6. It contains all joints of the photo.
According ATHENA, for mounting on:
Aprilia AF1 50cc from 1986 to 1990
APRILIA TUAREG 50cc and 50 from 1986 to 1990
APRILIA RED ROSE 50cc from 1986 to 1990
Reference: 5926
A high-end sealant for maximum resistance and sealing from -60° to + 250°.
Reference: VKM00040
Artein cutting joint sheets
Reference: 152122
Kit of four reinforced fiber gasket sheets 250°C, different thicknesses included.
Reference: 5910
A top-of-the-range joint compound for maximum resistance and tightness. This paste resists from -55 ° to 250 ° C without problem.
Reference: 86300010
High quality replacement gaskets, indispensable to the maintenance and perfect sealing of your engine.
Reference: P400160850100
Complete engine gasket set for GARELLI VIP 50 2T.
Reference: VJ.22.1
Indispensable for refurbishing the engine sealing of your Ø47mm aluminum ITALKIT kit.
Reference: 036.164
Elastic joint paste resistant to high temperatures. (300 ° C)
Reference: 156189
Two standard joint boards in 0.25 and 0.50mm + BA55 0.3mm cardboard joint + steel reinforced joint in 1mm
Reference: 279134_cgn
A good quality paste that resists up to 180 ° C with a maximum drying time after 24 hours.
Reference: P400150850221
For a total refurbishment of the engine sealing on your FRANCO MORINI 2T G30 LC 50 cm3 1992 to 1994.
Reference: 156190
A standard 0.50mm joint board + BA55 0.5mm cardboard joint
Reference: 171800
Ideal for safe and leak-free mounting of your exhaust.
Reference: P300000999001
Pack of ATHENA Racing cutting edges with joint pipe.
Reference: M813002000001
Paste with elastic joint and resistant to high temperatures. (300 ° C)
Reference: 440924
Cutting sheets to cut yourself ARTEIN 0.8 and 1.2 mm, ideal for the manufacture of cylinder head or exhaust!