Attention parts only reserved for the competition, prohibited on road!
We offer you the kit cylinder / piston without cylinder head 70cc Ø46mm cast in BARIKIT. It is cast iron and has 3 admission transfers and oval exhaust.
The diagrams are quite low at admission and low enough to escape making the torquey and not difficult to follow or set. The piston is a two-segment model! Clearly this kit has a very good ratio torque / power, it offers plenty of performance while preserving a great strength!
The piston is bi-model segments with segments for steels. We regret that it has no preparation on the rear apron to improve scanning and filling of admission. The finish is good. This kit will certainly be less effective than MALOSSI MHR, BIDALOT or Polini ... But there will already very good.
We recommend to accompany this kit with: carburation 19mm crankshaft and reinforced bearings, exhaust racing, drive racing, racing candle, 100% synthetic oil ....
The pack contains:
X1 cylinder cast iron 3 transfers
X1 Piston bi-segments
X2 Segments, purpose, steel, 1mm thick
X1 Piston pin Ø10mm X 38mm
X2 piston Clips Type G
Pack X1 engine top seal
Itself on:
HONDA 50cc VISION
KYMCO DJ
PEUGEOT Rapido 50cc
PEUGEOT ST
And many other models ...
Optional we offer a preparation course 1, this preparation is a modification of the channels and the exhaust port by increasing the charts and improvement of the duct, it increases the cylinder performance. Improved piston and bottom skirt is also included in the amendment. Allow a little extra time for this preparation!
.png)
