Reference: 19 4725
Set of 4 reinforced / elongated MALOSSI cylinder head nuts m7 thread Peugeot 103 / MBK 51 / AM6 / DERBI…
Very long and reinforced, these nuts allow tightening with more precision and withstand a higher tightening torque!
Banner
Asshole MVT RADIALE Ø47mm, specific for installation on cylinders AIRSAL Ø47mm on AV10 engine, MBK 51, AV7, MOTOBECANE...
In the incoming room, it allows to properly protect its varnished varnish joint, also but above all, it allows to enhance the cylinder with a hold by keeping a correct squish! It therefore offers an enhanced diagram of your cylinder. Place with a 1-1.5mm hold depending on the desired squish!
It has a long culot candle thread!
It gives a compression rate of about 13.5: 1 depending on the angle of your piston and the squish placed, a squish is recommended between 0.8 and 1.1mm depending on your mountings. Think to properly resurface your cylinder head before laying for a good planity!
Excellent squish area for a beautiful power transmission to the piston. Very nice heat exchange candle / assasse with the long ass, excellent heat dissipation of the engine heat calories thanks to its large size!
Culasse delivered with ash joint and does not have engine numbering location.
Reference: 19 4725
Very long and reinforced, these nuts allow tightening with more precision and withstand a higher tightening torque!
Reference: 06 3018B
An excellent seal, ideal for leak-free mounting.
Reference: 510599
Here is a long spacer for your MBK 51 AV7, AV10 motobecanes.
Reference: 510598
Here is a short spacer for your MBK 51 AV7, AV10 motobecans.
Reference: 182349
Here is a short spacer for your MBK 51 AV7, AV10 motobecans. 10mm thick.
Reference: adapt_av7
For adapting a low fixing cylinder head of av7, av10, an av10 engine... On a Motobécane Motoconfort AU Moped or AV88, AV87, AV89, SP50, AV78, AV79, AV98, AV68...with AV7 engine