Attention, only reserved for the competition, the circuits ... Prohibited on open road!
Here is the ITALKIT competition ignition for HONDA WALLAROO. This ignition does not have a 12v output (it is therefore without power for lighthouse, pump or other). For the manufacture of this ignition, ITALKIT has put with a major asset, the brand SELETTRA, these ignitions are already used for the competition by MALOSSI MHR or PARMAKIT.
So this is an ignition internal analog rotor (advance fixed) of very high quality, it is really very powerful, strong and well balanced to avoid vibration. It will allow you really great performance, we also prefer this model to fixed analog PVL models.
It comes complete with the machined plate mass, high voltage coil that has a high voltage cable, rotor, stator, hardware ... But also the manual. Otherwise, to have a circuit breaker, it's very simple, a cable comes out of the coil, just plug it on circuit breaker, neman, the ground ...
This ignition is stalled at 18 ° (ie 1.4mm before TDC "top dead center") with a setting rod. ITALKIT guarantees that this ignition follows the stability up to 27 000 revolutions per minute. Clearly, this ignition will be perfect on large competition configurations, it was also used on the famous MALOSSI MVR and other engine MALOSSI MG!
