• Banner

  • Kit 50cc aluminum air AIRSAL T6 Peugeot 103 / Fox & Honda Wallaroo

Kit 50cc aluminum air AIRSAL T6 Peugeot 103 / Fox & Honda Wallaroo

02020940

A fairly effective kit in single-segment, more efficient than the AIRSAL T3 or ORIGINS.

Stage 1 engine preparation
€58.33
Quantity
Shipping in 1-3 days.

Description

Here is the first price in Racing kit on the market, the AIRSAL T6 is a small 50cc kit with 6 transfers for Peugeot 103, FOX, HONDA WALLAROO air cooling. Certainly not expensive, but beware, we are very far from MALOSSI and POLINI although it is not so bad! The cylinder is therefore of good quality aluminum treated with nykasil, this nykasil is of medium range. It therefore has 6 intake transfers and a standard oval exhaust. The diagrams are good and between two torque / power (at our measurements on our 103 ° / 112 ° / 160 ° series, may vary depending on the series).


At the base, the transfers are slightly enlarged! Where we will be very disappointed, it is especially at the level of the channels which are really not studied… We are far from the design offices MALOSSI, POLINI, ATHENA,… But at such a price! We cannot have everything. Apart from that, the internal light finishing is relatively mixed and limited.



To get a better sweep, AIRSAL put a small piston with a preparation on the back skirt! In addition, this piston is in mono-segment to allow good high revs! The segment is obviously not hard chrome domed ... It is a standard segment. In short, this cylinder brings a good little performance gain and this for an unbeatable price! It is solid and of good quality, remember that we are far from Chinese material, AIRSAL is a Spanish brand known since time immemorial. We will not however consider this cylinder at all as a hyper racing and this will only be tightened because of its channels which are in no way studied.



We recommend this kit with
: high compression cylinder head, spark plug B9 to B10, detent exhaust, 0.30mm valve blade, carburetor settings, carburetor 15mm PHBG to operate well but not necessarily required.


The pack contains
:

Cylinder

Piston

Segment

Axis

Piston clips

Seals

notice

(attention, delivered with a gasket for exhaust to screw in Ø32mm, we sell separately the flange gaskets in 2 screws)



Optionally we offer you a stage 1 preparation, this preparation is a modification of the channels and the exhaust light by increasing the diagrams and improving the duct, it increases the performance of the cylinder. An improvement in the piston and bottom of the skirt is also included in this modification. Allow a little extra time for this preparation!

Product Details
You might also like