• Banner

  • Pack

Complete POLINI 70cc air engine for Peugeot 103 SP, MV, MVL, LM, ... (flexible mounting, with starter pedal and mainspring)

complet_polini_air_sp

A complete engine without variator, POLINI air cooling for PEUGEOT 103 type SP with spring and starter pedal.

Description

For quality reasons! We do not sell this engine with the first price original type ignition, we impose the assembly of a MVT PREMIUM!!!

This engine for PEUGEOT 103 air cooling with large casings and flexible assembly to avoid emulsions, it has:

MVT PREMIUM ignition set at 0° (choose electronic cone)

-Kit 70cc aluminum air cooling with cylinder head, 6 transfers, mono-segment POLINI W (prepared or not according to your choice)

-Carters POLINI large valves built-in support

- 21mm flexible intake pipe special POLINI casings

- POLINI carbon valves (you can place more efficient valves in your basket if desired)

-Carburetor 21mm POLINI CP SOFT pre-adjusted

-Specific POLINI air filter for SP

-Reinforced bearings C3 polyamide cage

-Reinforced crankshaft full masses POLINI (the most qualitative on the market)

- Crankcase screws, cylinder head, studs ... High quality

POLINI motor spring

POLINI launcher pedal

*Warning, depending on the chassis, it is possible that the carburettor goes badly, it may be necessary to grind the idle speed screw, or worse, to change the intake manifold!!!

**The engine comes with a decompressor, you can remove it and put a plug instead!

The whole is equipped, assembled according to the rules of the art (squish, volumes, improvements in the greasing of the big end and connecting rod feet, etc.), and checked. To better support this complete engine, you can install the new POLINI exhaust or another model.

Clearly it is still evolving but already very powerful!!! If you want to install a decompressor, plan to buy it because the block comes with a cap!

Give it a good run-in for 400km, and gently put the power on while adjusting your variation to try to exploit the 9,000 to 10,500 rpm as much as possible over the entire climbing range. And check your carburetor settings. 100% synthetic oil MOTUL 800 ROAD strongly recommended, 3% during the break-in, and gradually reduce (from 200km) to 2.5% or even 2% (too much oil lowers the octane rate and therefore engine performance, too little risk of tightening and too rapid wear)!

As an option, we offer an engine preparation, it allows to operate a speed of around 10,000 rpm against 8,500 for the stock version. This preparation includes a modification of the diagram and the exhaust channel, a slight retouching to increase the admission diagrams (lateral), an improvement of the admission on the piston and the rear cylinder skirt, a general improvement of the piston. An improvement of the group pipe / valves. To be accompanied by a good motor / variator spring adjustment to exploit the 10,500 rpm!

*Delivered without anti parasite

*Delivered without spark plug, b8hs recommended for break-in and adjustments, br9hix recommended after break-in and adjustments!

*Delivered without dimmer, the ER3 doppler is a very good dimmer.

*Delivered without strap, plan a good quality strap like the DOPPLER

*Delivered without mainspring, the original Peugeot is fine, but a DOPPLER is a real plus!

* Delivered without exhaust, you can accompany the engine of a POLINI , DOPPLER or other

*If your original 103 is 6V, provide bulbs and a 12V voltage regulator to go with your MVT PREMIUM ignition

Product Details
You might also like

This pack contains

16 other products in the same category: