Attention, only reserved for competition, circuits ... Forbidden on open road!
Here is the ITALKIT ANALOGUE competition ignition for old BULTACO engine from 250 to 370. This ignition does not have a 12v output (it is therefore without power supply for headlight, pump or other). For the manufacture of this ignition, ITALKIT has put itself with a major asset, the SELETTRA brand, these ignitions are already used for competition by MALOSSI MHR or even PARMAKIT.
This is therefore a very high quality analog internal rotor ignition (fixed advance), it is really very powerful, solid and well balanced to avoid vibration. It will really allow you very high performance, we also prefer this model to fixed analog PVL models.
It is delivered complete with the mass-machined plate, the high-voltage coil which has a high-voltage cable, the rotor, the stator, the screws, a ground braid ... But also the instructions. Otherwise, to have a circuit breaker, it's very simple, a cable comes out of the coil, just connect it to the circuit breaker, neman, to the mass ... This ignition is wedged at 18 ° (i.e. 1.4mm before TDC "top dead center") with a setting rod.
ITALKIT guarantees that this ignition follows stability up to 27,000 revolutions per minute. Clearly, this ignition will be perfect on large configurations, not too much push either, after it is better to switch to the variable which guarantees a follow-up in the highest speeds without loss of torque thanks to the auto-shift according to the speed. motor.
Mounts on all engines of old motorcycles BULTACO 250, 350, 360, 370, Pursang, Frontera, Alpina, Sherpa ...
