Reference: 515588
Crankshaft bearing reinforced polyamide cage FAG 6303 C4 17X47X14mm original size for minarelli am6
Ideal to strengthen your low engine minarelli am6 with quality material.
PEUGEOT 103
MBK 51
MOTOBECANE
PIAGGIO CIAO / VELOFAX
PEUGEOT FOX
HONDA CAMINO, PX, PXR...
DERBI VARIANT
SOLEX
PUCH
MINARELLI AM6
Low-pass exhaust pipe
High-pass exhaust pipe
DERBI Euro 3 / 4 / 5
DERBI Euro 1 & 2
MINARELLI P4 & P6
MINARELLI RV6, RV5, RV4, RV3
SUZUKI SMX, RMX, TSX
YAMAHA TY, RD, DT, MX
HONDA MB, MT, MTX, MBX, NSR R
YAMAHA CHAPPYBanner
Complete pack of very high quality spy seals because manufactured at motors parts (top performance group and minarelli), avoid copies of dubious quality, enough to change all your engine spy seals and therefore be quiet after your engine reassembly, it will be a shame to close its casings and have leaks, do not take the risk.
This pack gives you the choice between 2 spy seals for the ignition side! The original aluminum type coupled viton or the complete viton!
The pack contains :
X1 clutch pull rod seal
X1 gear selector gasket
X1 gearbox outlet seal
X1 clutch side seal for crankshaft
X1 viton racing ignition side seal
X1 seal on the ignition side viton alloy couple
X1 water pump seal
Reference: 515588
Ideal to strengthen your low engine minarelli am6 with quality material.
Reference: 6616065E
C4 reinforced bearings, high precision competition!
Reference: 517941
Essential to refurbish the motor seal of your mecaboite!
Reference: P400130400204/1
A complete seal pack for a refurbishment of your engine!
Reference: 285.0136
Spur gaskets (spinnaker) competition crankshaft, high-end model POLINI amount side ignition.
Reference: 488824
A high-end pack, ideal to accompany a well-prepared engine configuration with large bristle crankshaft (bearing seats) Ø20mm!
Reference: KK01001
A high quality pack, to reinforce a low engine with a bristle crankshaft (bearing bearings) of original size Ø17mm! C3 models reinforced polyamide cage with racing spy joints!
Reference: 6611566E
Reinforced bearings that will support large configurations without any problem.Available in C3 or C4 set!
Reference: P400010444001
Ideal to accompany and strengthen a crankshaft with bristles (bearing seats) of original size Ø17mm! C3 models reinforced polyamide cage with Viton spy joints.
Reference: KCR-05
Ideal to accompany a crankshaft with large bristles (bearing bearings) in Ø20mm diameter on a prepared configuration! Set of reinforced bearings C3 sizes + spy glass joints.
Reference: 478939
The must of bearings and spy joints for a solid and tight assembly.
Reference: 488031
Ideal for reassembling your crankshaft while solidifying it to the maximum. This pack will be perfect on 50cc and 70cc kits Very good quality!
Reference: 8859
Ideal for strengthening your lower minarelli engine with quality material.
Reference: 162515
A bearing that will support all your most advanced configurations. Real ceramic competition piece!
Reference: 285.0003
High quality oil seal for MINARELLI AM6 engine
Reference: 489849
Ideal to strengthen your low engine minarelli am6 with quality material.