Test bench control tool Vilebrequin metrological test (concentricity, false circles, balancing) installation at bearing and poin

The adjustable and affordable tool for the metrology of your crankshafts! To be accompanied by a quality comparator to read the false circles. We recommend to oil the bearings at the WD40 during use. Also suitable for crankshafts that do not have the same landing on the left as has right because adjustable height. This very complete version makes it possible to take points but also to compensate!

It is valid for crankshafts, but also for cam trees and all other parts!

As required, measurements can be made using the provided counter-points or bearing supports mounted on the "L" calipers. One of the two "L" supports is height adjustable to accommodate different tree diameters.

The rectified pin provided has a diameter of 12 mm and a length of about 330 mm; it comes with 2 center cones to control components without internal shaft or with bearings such as clutch bells and motorcycle rims. The profiles consist of 10 mm thick galvanized steel plates and 6 mm thick galvanized steel supports.

The Balancing Tool comes without comparison.