Not approved on the road, cylinder not complying with the 50cc cylinder!
Here is a very good alu kit for HONDA MTX 2 50cc air cooling. A real high-end Made In Italy. The cylinder is therefore an aluminium model with a high quality nicasil coating. The channels, the finish... everything is excellent!
Has 6 transfers, of which 2 on each side and 3 at the specific rear. Its intake is expanded and optimized to improve filling. A very powerful kit! With its diameter of 44,5mm, it still offers 70cc and will combine a maximum of torque & strength!
The piston is a high-end model. The latter is equipped with two openings on the back in order to promote filling / sweeping at the level of your intake, its attachment bow for the collector / intake pipe is 61 X 40mm. It delivered you with a 98 carburettor gicler in order to optimize the performance of the cylinder
Accompanied by 2 segments of 1.5mm thick chrome steel, reinforced clips type G and Ø12mm axis. Clearly, a high performance cylinder/piston that will offer you strength, reliability and performance both in low speeds (couples) and high speeds! A real gem at home MALOSSI.
The pack contains:
-Cylinder aluminium Ø44,5mm
-Piston reinforced Ø44,5mm with preparation on the rear skirt
-2 steel segments, thickness chromes 1.5mm
-Pack joint-Notice, delivered of use
-Stickers
Characteristics :
Material: aluminium
Cooling: air
Gear: 44.5 mm
Course: 41.4 mm
Cylinder: 65cc
Compression ratio: 10,5:1
Distribution: 6 transfers
Installs on the bikes:
-HONDA MB 5 (speed) 50
-HONDA MT 5 (speed) 50
-HONDA MTX (automatic) 50
-HONDA MTX 5 (speed) 50
-HONDA NSR (automatic) 50
Optionally we offer you an internship preparation 1, this preparation is a modification of the channels and exhaust light by increasing the diagrams and improving the duct, it increases the performance of the cylinder. An improvement in the piston and skirt stock is also included in this modification. Count an extra time for this preparation!
